What stays equivalent when an ND filter changes?
A neutral-density filter reduces the light reaching the sensor. Under a steady scene and an ideal neutral filter, keeping the same aperture and ISO therefore requires a longer exposure. A loss of three stops transmits one eighth of the light, so exposure time must increase eightfold. Removing that same filter reverses the adjustment.
The calculation compares the absolute baseline stack with the absolute target stack. If a two-stop filter stays in place and a further one-stop filter is added, enter two stops at baseline and three stops at target. Entering only the new one-stop filter as the target would instead describe a reduction in total attenuation.
For f-number N, time t in seconds, ISO S and absolute ND loss k in stops, the equivalent-time relationship is:
t₂ = t₁ × (N₂/N₁)² × (S₁/S₂) × 2^(k₂ − k₁).
The squared aperture ratio follows the area change associated with f-number. Doubling the f-number requires four times as much time when the other inputs stay fixed. Doubling ISO halves the required time in this nominal setting model. Nikon’s exposure-mode explanation illustrates the relationship between shutter time and aperture; the tool also solves the equation for aperture or ISO when time is held fixed.
Setting EV and scene-equivalent EV answer different questions
Setting EV is log₂(N²/t). Normalising that setting to ISO 100 subtracts log₂(S/100). These are camera-setting descriptions; adding the filter loss gives the unfiltered-scene equivalent EV100 within the same ideal exposure model.
In an artificial example, f/8, 1/128 s and ISO 100 without a filter give setting EV100 = 13. Adding three stops of ND changes the equivalent time to 1/16 s, giving setting EV100 = 10. Adding the three-stop attenuation back gives scene-equivalent EV100 = 13. The scene has not become three stops darker simply because a filter was placed in front of the lens.
Neither figure is converted to lux here. A lux-to-camera-exposure relationship needs an identified incident-meter calibration and measurement basis; reflected-light metering also depends on what is being measured. An EV display alone does not supply those missing conditions.
Stops, optical density and transmission
For fractional transmission T, the loss is −log₂(T) stops, while optical density is −log₁₀(T). Ideal stacked transmissions multiply, so their stop losses and optical densities add.
Manufacturer labels may round these relationships. LEE’s filter records illustrate the product-specific context of filter data. Real spectral transmission, reflections, lens T-stop differences and filter tolerances are not recovered from a nominal ND number.
Frame rate and shutter angle describe the exposure window
The cine relationship is t = angle ÷ (360 × frames per second). At 25 frames/s and 180°, the time is 0.020 s, or 1/50 s. Sekonic’s L-308X-U specifications identify cine frame-rate and shutter-angle measurement modes. The angle is not a claim that every camera implements the same readout behaviour.
Exposure time is shown with significant digits, with a reciprocal expression for times no longer than one second. Very short times are not rounded to 0.00 s. Calculated f-numbers and ISO values remain arithmetic values rather than recommendations for the nearest available camera dial position. Film reciprocity failure, flash synchronisation, moving-subject blur and light-source banding require separate consideration. For manual flash exposure from a matched manufacturer rating, use the Flash Guide Number Calculator.