Illuminance and duration describe different parts of exposure
A lux reading describes illumination at a surface at a particular time. An object left under that light accumulates exposure for as long as the condition continues. The Canadian Conservation Institute’s explanation of light and its exposure defines the practical quantity as illuminance multiplied by duration, expressed in lux-hours.
For one constant period, exposure = illuminance in lx × time in hours. For several periods, add their products:
Total exposure = Σ(E × t), in lx·h.
This is different from the electrical energy consumed by the lights. A lamp’s watts do not tell you the lux received by an object, and kWh cannot be substituted for lx·h. The energy tool answers the separate electricity question.
Combine changing periods without double-counting
Suppose an artificial display receives 50 lx for 8 hours, then 150 lx for another 2 hours. Its exposure is:
These periods occur in sequence. Do not enter an overall period and also its component periods, because that would count the same exposure twice. If the illuminance changes continuously, a representative time average or a finer set of periods is needed. A short peak reading applied to every hour may overstate exposure; a single low reading can understate it.
Zero lux or zero duration contributes zero exposure. An empty value is missing information, not a zero reading. The displayed exposure rounds to two decimal places while the calculation retains its intermediate values.
Translate a supplied budget into time
Assume an artificial budget of 1,000 lx·h for the same object and accounting period. After the 700 lx·h above, 300 lx·h remains. At a future constant 50 lx, that permits 300/50 = 6.00 hours within this arithmetic budget.
If the budget were 600 lx·h, the accumulated exposure would exceed it by 100 lx·h. Remaining time would be zero, not a negative allowance. A blank budget leaves this comparison unavailable while retaining the calculated exposure. The calculator supplies no recommended budget.
A dose alone does not predict damage
Two lighting conditions with equal lux-hours need not have the same effect on every material. Spectral distribution, object sensitivity, UV, IR, previous exposure and other conditions matter. This tool does not estimate fading, material lifetime or a safe display policy.
Use a reading for the relevant object surface. If its unit is foot-candles or kilolux, convert the same illuminance before using it. Several spatial readings from different objects are not automatically a time series for one object, even if their sample statistics are available.